10
OPERATING YOUR BLACK LABEL CLEVERSPA
®
Press
SET TEMP/LOCK
and the numbers on display
screen will start to flash. Increase/decrease
temperature by pressing
TEMP UP
or
TEMP DOWN
.
Choose desired temperature, press
SET TEMP/LOCK
again to confirm. Temperatures can be
set between the range of
20°C to 40°C
.
(See safety instructions for recommended
operating temperatures).
Press
AIR JETS
to start the bubbles - a blue light will
appear. Press again and air jets will stop working -
blue light will go out.
Air Jets Function:
Air jets will stop automatically after 20 minutes of
continuous use, to avoid internal pump overheating.
They can be started again after 10 minutes.
Air jets can be stopped or started again at any time
during their 20 minute cycle.
CONNECTING YOUR CLEVERLINK® APP
1. Check your CleverSpa
®
is in a location with strong WiFi coverage (see pg 5).
2. Download the CleverLink® App on your smart device, from the App Store
or Google Play.
3. Register your account.
4. Follow on screen instructions regarding how to pair CleverSpa
®
to your WiFi.
5. You are ready to go!
*Internet access required.
N.B. CleverLink® is only available on selected CleverSpa® models
SETTING THE TEMPERATURE
Press the
HEATER
blue light will appear. Press
HEATER
again and heating system will stop, blue
light will go out.
When heater system is on, filter system will switch
on automatically to circulate water.
When temperature has reached
1°C
above pre-set
temperature, heating system will stop working,
but light will remain on. Filter pump will continue
to operate even when heater is not functioning.
When water falls
1°C
below pre-set temperature,
heating system will automatically heat water back
to
1°C
above
selected temperature. Once achieved,
heater will stop to allow temperature to settle at
pre-set value.
HEATER
INFLATE/AIR JETS
FILTER CHANGE
FILTER
Press
FILTER
, blue light will appear, pump will
start to work. Press
FILTER
again to stop pump,
blue light will go out.
After approx. 168 hours,
FC
code will appear on display
screen. It reminds users to check/replace their filter.
Blue light will be lit on
FILTER
. Pump and
heating
system will continue to operate as normal and blue
lights will be on.
To clear the
FC
code, press
FILTER
. the
FC
on display
screen will disappear and the water temperature will
be displayed. All functions will return to normal.
When turned on,
365 FREEZEGUARD
will activate
the filter and heater and maintain the water
temperature at
5°C
to help prevent the water
freezing at low temperatures.
Press
365 FREEZEGUARD
, blue light will appear,
filter and heater will be activated & blue lights will
appear. Controls will be disabled.
Press
365 FREEZEGUARD
again, blue lights will go
out, filter and heater
will be deactivated, all control
will be re-enabled.
365 FREEZEGUARD
IMPORTANT! FILTER CYCLE
After the pump and heater is turned off, the filter
will continue to run for a couple of minutes to avoid
overheating.
The blue filter light will flash during this time.
DO NOT REMOVE THE FILTER UNTIL THE CYCLE
HAS COMPLETED TO AVOID DEBRIS GETTING
INTO THE SYSTEM, CAUSING POTENTIAL DAMAGE.