FIT LIGHTS LOOSELY – HOT TUB WILL EXPAND WHEN FILLED!
Correct installation is extremely important.
Failure to follow instructions carefully may result in failure.
LED LIGHTING SETUP
(Selected Models Only)
INITIAL SETUP
1. Assemble LED Lighting Kit.
2. Remove plastic tape from the battery compartment on the remote.
3. Turn lights on with the power button.
FIG 1 - HOW TO FIT LED LIGHTS CORRECTLY
Shape and Style of CleverSpa®
may differ from image shown
IMPORTANT!
LEDS MUST FACE THE BASE
FIRST LIGHTING LOOP
LAST LIGHTING LOOP
RF REMOTE
CONTROL
& CR2025
3V BATTERY
PLEASE NOTE:
Note the placement
of alignment notches
RF Wireless Receiver
LED Light Strip
2
3
1
Mains Power Converter
LIGHTING EQUALLY
SPACED AT THE
START AND END
1. Search CleverLink
®
on App Store/Play Store and download app.
2. Once CleverLink
®
is installed on your device, tap the icon to launch.
3. Setup an account, following all the relevant steps.
PAIRING YOUR CLEVERSPA
®
4. Ensure your device is set to the same 2.4GHz wireless network
as the CleverSpa
®
hot tub you are connecting to.
IMPORTANT! You need a strong WiFi signal to connect.
5. Select the control panel version that your hot tub is fitted with.
6. Input the ‘Network Name’ and ‘Security Password’ for your wireless
network. This can usually be found on your wireless router.
7. Review the tip about hot tub placement and press ‘NEXT’.
8. Hold the CleverLink
®
Pairing button on control panel, (wait for beep)
then tick the confirmation box on-screen and tap,
Pair your CleverSpa
®
.
9. CleverLink
®
will now try to establish a connection between your device
and your CleverSpa
®
hot tub. This can take up to 60 seconds
to complete.
(DO NOT leave the setup screen).
10. Once the pairing process is complete you should see a
‘Green Tick’
.
Click “finish” to finalise the process. If you see the
‘Red Tick’
“Pairing Failed” on screen, try completing the pairing process again.
Be sure to check your wireless network settings are correct and
that your device and hot tub are both in range and connected to a
2.4Ghz network.
11. Once you see the green tick, activate a function on the hot tub
control panel such as the air jets. This will sync the control panel
and app. Setup is now complete.
FOR BEST SIGNAL QUALITY WE RECOMMEND
THE USE OF A 2.4GHz WIFI RANGE EXTENDER
CLEVERLINK® APP SETUP
(Selected Models Only)
STRONG
FAIR
POOR
SCAN ME FOR
CLEVERLINK® SETUP