12
CLEANING & STORING AWAY YOUR CLEVERSPA
®
HOW TO EMPTY YOUR CLEVERSPA
®
1.
Remove CleverSpa
®
plug from electrical mains.
2.
Unscrew cap from water outlet
(L)
below pump system of CleverSpa
®
. Ensure Drainage Plug
(G)
is still inserted to prevent unexpected draining.
3.
Screw inflation hose
(D)
onto the water outlet
(L)
and direct open end of hose appropriately.
4.
Remove drainage plug from outlet within floor of CleverSpa
®
, so water can flow out.
5.
Once drained use a sponge to absorb excess water; then operate air jet function for up to
20 minutes (one full cycle) to drain any water and dry out the pipeline. If not completely dry
after first cycle – repeat.
6.
When draining has finished, remove inflation hose
(D)
and replace drainage plug
(G)
and water
outlet cap
(L)
.
HOW TO DEFLATE YOUR CLEVERSPA
®
1.
Locate the black two-part air valve (see point 9 on ‘setting up your CleverSpa
®
).
2.
Fully unscrew and remove rapid deflation air valve by turning anti-clockwise
(K)
.
3.
Fold hot tub away carefully to remove as much air as possible through the open valve.
STORING YOUR CLEVERSPA
®
Make sure all water is completely drained from the CleverSpa
®
and pump system. This is vital in
extending the life of your CleverSpa
®
. We recommend the use of a wet/dry vacuum to help blow out/
suck up water from pipes and pump lines. Remove filter cartridge.
CleverSpa
®
should be placed in bag provided and stored in a dry place, raised off floor and away from
extreme temperatures.
Please note:
When not in use, store in a place that is dry and a moderate temperature, as subzero
temperatures can severely damage your CleverSpa
®
.
WHEN TO CHANGE YOUR CLEVERSPA® FILTER
Keep your CleverSpa® hot tub clean and safe from contaminants. For optimum
performance, unscrew the filter and rinse with clean water after every use to
remove any small particles and residue. The filter is one of the most important
elements to ensure your CleverSpa® hot tub works effectively.
1.
Remove filter ‘sock’ protective cover (C) then remove filter (B).
2.
Rinse the filter under a cold tap and reuse. Alternatively, machine wash your
filter (place in a pillowcase) to keep it clean and to maintain its performance.
Replace your old filter with a new one if:
• The filter remains soiled after cleaning
• Holes are visible in the paper
• The paper is noticeably worn
3.
Replace filter ‘sock’ protective cover (C) over filter (B) and attach to filter connector (N)
by turning it clockwise. Do not over tighten, as this may cause a ‘rattling’ noise.
REMEMBER - CHECK YOUR FILTER EVERY DAY!
To help to keep your water clean, check your filter cartridge every day.
To order filters and chemicals for your CleverSpa
®
, please visit: clevercompany.com
FILTER
CARTRIDGE (B)
FILTER PROTECTOR
COVER (C)
