POWER
On / Standby
CHANGE MODE
Forwards / Backwards
CHANGE SPEED OF LIGHTS
‘+’ Faster / ‘–’ Slower
CHANGE COLOURS
Forwards / Backwards
PRE-SET COLOURS
Select from a range of
pre-set solid colours
BRIGHTNESS
Adjust Lighting brightness (5 levels)
: Increase Brightness
: Decrease Brightness
DEMO MODE
Cycles through pre-set colours & effects
A
B
C
D
E
F
G
A
C
G
F
E
D
1. Connect lighting system together as shown on page 8.
2. Remove plastic tape from the battery compartment on the remote.
3. Turn lights on with the power button.
If colours pressed on the remote are activating incorrect colours on the light strip:
1. Ensure the lights are turned on using the red power button.
2. Press the solid Green button once.
3. Switch off the ‘Power’ at the mains for 5 seconds then turn back on.
4. Press and hold the solid green button immediately after turning on.
5. Release the button when the colour changes.
6. Wait 5 seconds for the change to take effect.
INSTRUCTIONS
09
HOW TO USE YOUR CLEVERSPA
®
LED LIGHTING RF REMOTE CONTROL
INITIAL LIGHTING SETUP
B
+
–
