1
2
3
4
5
6
A
B
B 8
T r o u b l e
operation
possible cause:
The system has crashed because of a software con-
flict.
solution:
Consult your operating system manual. As a last resort,
since you will lose any unsaved data, try to reboot the
system or if that doesnt work, turn the computer off and
on again.
possible cause:
The system cannot access the
Save to Disk
partition.
indicator:
The system retrieves
Save to Disk
information very
quickly during bootup and then freezes.
solution:
This situation usually happens after one of the following
occurs and you activate the
Save to Disk
process: (1) the
hard disk has been changed; or (2) there has been a CMOS
failure or a Checksum failure and the problem has not
been corrected. If one of these occurs, you must run the
PhDisk
utility as soon as possible. Refer to Setting up for
Save to Disk
in
Chapter 5: Power
.
The
Save-to-Disk
function does not work.
possible cause:
The system cannot access the
Save to Disk
partition.
indicator:
When you press the
Fn
+
key combination, normal
Suspend
is activated instead of
Save to Disk
.
solution:
(1) Check if you have enabled
Save to Disk
in the Power
Savings menu in
Setup
. Refer to
Chapter 4: Firmware
.
(2) You may not have set up the
Save to Disk
partition.
Refer to
Chapter 5: Power
to setup the partition.
Summary of Contents for 9800
