1
2
3
4
5
6
A
B
B 11
post errors
message:
Failing Bits: nnnn
description: The hex number, nnnn, is a map of the bits at the RAM address
that failed the memory test.
solution:
1. Make sure the expansion memory is seated properly in its
socket(s) (refer to
Chapter 6: Extras
).
2. Run Setup to allow the system to recheck the amount of
memory present, then save the Setup information and reboot
(refer to
Chapter 4: Firmware
).
3. Turn off the system and remove any DIMMs (refer to
Chapter
6: Extras
). Restart the system. If the problem persists, contact
your service center. If the problem disappears, replace the
DIMMs one at a time to identify the defective module. Replace
any defective DIMMs.
message:
Fixed Disk
x
Failure
or
Fixed Disk Controller Failure
description: The hard disk is not working or is not properly configured.
solution:
1. Check that the HDD is properly attached (refer to
Chapter 3:
Media
).
2. Run
Setup
to make sure the HDD is correctly configured
(refer to
Chapter 4: Firmware
).
3. Make sure the HDDs jumper settings are correct - master
for both (refer to
Chapter 3:Media
).
message:
Incorrect Drive A: type - run Setup
description: The FDD is incorrectly identified in
Setup
.
solution:
Run Setup and check the settings for the FDD, usually 1.44MB/
3
1
/
2
, (refer to
Chapter 4: Firmware
).
Summary of Contents for 9800
