Disassembly
Removing and Installing a Processor 2 - 13
2.Disassembly
Removing and Installing a Processor
Processor Removal Procedure
1.
Turn
off
the computer, turn it over, and remove the battery (
), component bay cover (
RAM (
2.
The CPU heat sink will be visible at point
(
).
3.
Remove screws
-
from the heat sink unit in the order indicated on the label (i.e screw
first through to
screw
)
.
4.
Carefully (it may be hot) remove the heat sink unit
(
).
A
1
4
4
1
B
a.
b.
2
1
4
A
c.
3
B
B
Figure 9
Processor Removal
a. The CPU heat sink will
be visible at point
.
b. Remove the screws from
the CPU heatsink.
c. Carefully lift the heat
sink up and off the com-
puter.
A
B. Heat Sink
•
4 Screws
Summary of Contents for N650DU Series
