Disassembly
2 - 6 Removing the Keyboard
2.Disassembly
Removing the Keyboard
1.
Turn
off
the computer, turn it over.
2.
Remove screws
-
from the bottom of the computer.
3.
Open it up with the LCD on a flat surface before pressing at point
to release the keyboard module (use the spe-
cial eject stick
to do this) while releasing the keyboard in the direction of the arrow
as shown (
a
).
4.
Carefully lift the keyboard
up, being careful not to bend the keyboard ribbon cable
. Disconnect the key-
board ribbon cable
from the locking collar socket by using a flat-head screwdriver to pry the locking collar pins
away from the base (
).
5.
Carefully lift the keyboard
).
1
2
3
4
5
6
7
7
8
6
a.
b.
1
2
c.
6
7
8
6
3
4
8
5
4. Eject Stick
6. Keyboard
•
2 Screws
Figure 2
Keyboard Removal
a. Remove the screws from
the bottom of the compu-
ter and then eject the
keyboard using a special
eject stick to push the
keyboard out while re-
leasing the keyboard as
shown.
b. Lift the keyboard up and
disconnect the keyboard
ribbon cable from the
locking collar socket.
c. Remove the keyboard.
Re-inserting the Key-
board
When re-inserting the
keyboard firstly, align the
keyboard tabs at the bot-
tom of the keyboard with
the slots in the case.
Summary of Contents for N855HC
