Disassembly
Removing the Hard Disk Drive 2 - 7
2.Disassembly
Removing the Hard Disk Drive
The hard disk drive can be taken out to accommodate other 2.5" serial (SATA) hard disk drives with a height of 9.5mm
or 7mm (h). Follow your operating system’s installation instructions, and install all necessary drivers and utilities (as
outlined in
Chapter 4 of the User’s Manual
) when setting up a new hard disk.
Hard Disk Disassembly Process
1.
Turn
off
the computer, and remove the battery (
2.
Remove the SD card cover
and screws
-
).
3.
Carefully lift the bottom case
up from point
and remove it (
)
.
4.
The HDD will be visible at point
on the mainboard (
)
.
6
1
2
17
18
19
20
2
a.
b.
1
3
4
5
18
13
20
6
7
17
8
9
11
12
14
15
10
c.
18
19
16
Figure 3
HDD Assembly
Removal
a. Remove the SD card
cover and screws.
b. Remove the bottom
case.
c. Locate the HDD.
20. Hard Disk
•
16 Screws
Summary of Contents for N855HC
