Disassembly
Removing the Hard Disk Drive 2 - 7
2.Disassembly
Removing the Hard Disk Drive
The hard disk drive can be taken out to accommodate other 2.5" serial (SATA) hard disk drives with a height of 7mm
(h). Follow your operating system’s installation instructions, and install all necessary drivers and utilities (as outlined in
Chapter 4 of the User’s Manual
) when setting up a new hard disk.
Hard Disk Disassembly Process
1.
Turn
off
the computer, and remove the battery (
2.
Remove the SD card cover
and screws
-
).
3.
Carefully push to release the bottom case
from point
and then lift it up from point
to release the bottom
case and ports as indicated by the arrows (
)
.
4.
The HDD will be visible at point
on the mainboard (
)
.
6
1
2
17
18
19
20
21
2
a.
b.
1
3
4
5
18
13
21
6
7
8
9
11
12
14
15
10
c.
18
19
16
20
17
Figure 3
HDD Assembly
Removal
a. Remove the SD card
cover and screws.
b. Remove the bottom
case.
c. Locate the HDD.
18. Bottom Case
•
16 Screws
Powering the
Computer On
After every disassem-
bly, make sure that the
bottom case’s screws
are all inserted and
tightened before turn-
ing the computer on.
Summary of Contents for N870EK1
