Disassembly
Removing and Installing the Processor 2 - 11
2.Disassembly
Processor Installation Procedure
1.
Insert the CPU
), pay careful attention to the pin alignment, it will fit only one way (DO NOT FORCE
IT!), and turn the release latch
towards the lock symbol
(
).
2.
Insert the heat sink
at an angle of around 30° as indicated in
.
3.
Tighten the CPU heat sink screws in the order
,
,
,
,
,
&
(the order as indicated on the label
and
).
4.
Replace the component bay cover.
A
B
C
1
2
3
4
5
6
7
b.
B
a.
C
Note
:
Tighten the screws in the order
as indicated on the label.
A
c.
d.
2
1
3
4
6
5
7
Figure 7
Processor
Installation
a. Insert the CPU.
b. Turn the release latch to-
wards the lock symbol.
c. Insert the heat sink.
d. Tighten the screws.
A. CPU
C. Heat Sink
•
7 Screws
Summary of Contents for W230ST
