WWW
.
CLF
-
LIGHTING
.
COM
8
.
0
SETUP
Warning! Read “Safety Information” on page 2 before installing, powering, operating the fixture.
Control panel and menu navigation
The onboard control panel and backlit graphic display are used to set the fixture’s DMX address, configure
individual fixture settings (personality), read out data and execute service utilities. See “Onboard control
menus” on page
or a complete list of menus and commands.
Using the control buttons
• To enter the menu select [MODE].
• Press [UP] and [DOWN] to scroll within a menu or adjust values.
• To enter a menu, select a function or apply a selection, press [ENTER].
• To escape a function or move back one level in the menu structure, press [MODE].
• Holding down the "UP" and "DOWN" button for more than 3 seconds, the MENU display will rotate 180°.
DMX address setting
Control mode
15 f
The DMX address, also known as the start channel, is the first channel used to receive instructions from the controller.
For independent control, each fixture must be assigned its own control channels.
The DMX address is configured using the DMX ADDRESS menu in the control panel. For setting the DMX
address press [ENTER] before you can change the adddres.
1
、
DMX operate mode setting
Access control panel function by pressing MODE until
【
RUN
】
is displayed.
Press ENTER, press UP/DOWN buttons until the
【
DMX
】
is displayed.
Press ENTER, Press MODE return to MENU
2
、
Setting DMX512 Address
Access control panel function by pressing MODE until
【
DMX
】
is displayed.
Press ENTER, add or reduce channels by pressing UP/DOWN between 001 and 512.
Press MODE to exit.
DMX control mode is selected in the CONTROL MODE menu. The fixture has 8 DMX control modes:
4ch
5ch
6ch
8ch
10ch
12ch
16ch
HSV
Dimmer
RGBW
Strobe
Dimmer ( BAR1/2 )
RGBW( BAR1/2 )
Strobe
( BAR1/2 )
Macro color
White presets
Effect
Dimmer
/
Effect
speed
I
D
