6
INSTALLATION AND OPERATING INSTRUCTIONS
Note:
When the ambient relative humidity is 1% lower than the
selected relative humidity ratio percentage (RH %), the unit
compressor will switch off and unit will operate at a Low (L)
speed level.
Note:
When the ambient relative humidity is 5% higher than the
selected relative humidity ratio percentage (RH %), the unit will
switch on and unit will operate at the selected SPEED setting.
Note:
The unit will continuously run, regardless of the ambient
relative humidity, when the CON (continuous dehumidification)
mode is set.
5. To select ON/OFF timer.
To set automatic OFF timer, press TIMER button when unit is
powered ON; select the desired running time 1/2/4/8 hours
respectively, timer LED lights will illuminate accordingly. Unit will
automatically switch OFF once selected OFF time duration has
lapsed. The screen will display time elapsed and remaining
running time.
To set automatic ON timer, press TIMER button when unit is
powered OFF or on standby mode, select the desired time for unit to
start operating at 1/2/4/8 hours respectively, timer LED lights will
illuminate accordingly. Timer symbol will be displayed on screen.
6. To select auto dehumidification setting, press AUTO button, the
AUTO LED light will remain illuminated. Unit will automatically
adjust the humidity setting according to the ambient
temperature.
Note:
When the ambient relative humidity is less than or equal to
24°C, the relative humidity ratio setting is 80%.When the ambient
relative humidity is less than or equal to 24°C - 25 °C, the relative
humidity ratio setting is 60%.When the ambient relative humidity
is greater than or equal to 25°C, the relative humidity ratio setting
is 40%.
Note:
When AUTO humidity setting is activated, the previous
relative humidity ratio or continuous mode will be deactivated.
7. As unit operates, condensed water will drain into water
reservoir. When water reservoir is full unit will beep 10 times
and WATER FULL
indicator light will illuminate and all other
indicator lights will turn orange. Unit will automatically stop
operating. The water reservoir must be removed and emptied
before unit will operate again. See Fig 1.
Note:
Allow minimum of three minutes before turning unit on, after
water reservoir is emptied.
Fig 1
Remove water
reservoir in
accordance with
arrow direction
