To en able valet mode
1. Turn the ignition switch to its “ON” position or start the engine.
2. Enter your secret valet code on the PlainView switch, then return the switch to its
center position.
3. You now have 5 seconds to press the latched position to enter valet mode. The
LED on the PlainView switch will glow continually for on-going visual
confirmation of valet mode.
To exit valet mode
1. Turn the ignition switch to its “ON” position or start the engine.
2. Flick the switch back to its center position. The LED on the switch will turn off
to confirm that the system is now in its normal operating mode.
Setting your own secret valet code
Since all Clifford systems have the same factory-set code, it is highly advisable that
you set your own valet code. You may choose any 1-, 2-, or 3-digit code that does
not have any zeros. You may also change your valet code whenever you want.
Simply write down the 1-to-3 digit code you wish to use (remember, no zeros in the
code), then refer to the User-selectable features section on page 13.
Ex am ple
Let’s say you want to set your valet code to 31. To do so, you would do the following:
1. From the table of User-selectable features on page 13, you would note that the
“set new valet code” feature number 11.
2. Enter program mode by turning on the ignition, then enter your current valet
code (if still the factory default, this would be momentary, momentary, latched).
3. Select feature number 11 by tapping the momentary side of the switch 11 times.
To help you count, the switch’s LED will, after the first 3 taps, blink once each
time you tap the momentary side. Therefore, you’ll see a total of 8 blinks for
feature 11.
4. Immediately flip the switch to the latched position.
5. Enter you new code. To enter 31 as your new code, you would press the switch in
this manner: momentary, momentary, momentary, latched, momentary, latched,
center.
6. Wait 3 seconds until you see two LED blinks, indicating the new code has been
accepted.
7. Turn off the ignition to exit program mode.
8. VERY IMPORTANT: You must immediately test your new secret valet
code: Turn on the ignition, enter your new code, then flip the switch to its
latched position. The LED on the switch will illuminate. If it does not, the new code
you programmed and the one you just entered do not match. In such a case, the
system will revert to the previous code.
11
