10
© 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c .
Page notification
The remote control can be programmed to notify the user of a
page (audibly beeping if the vehicle’s status changes, e.g. door
unlocked, engine started, vehicle violation, etc.). Press
to
select page On/Off. One beep is page On, Two beeps is page Off.
When programmed off the remote will not give any notification
that a page was received from the vehicle.
To exit programming mode
The remote control will exit programming mode after 2-seconds
of inactivity and will emit 2 long beeps.
u
ussiin
ng
g yyo
ou
urr ssyysstte
em
m
The buttons used in the instructions in this manual correspond
to the standard configuration. Remember, this is not the only
way your 2-way remote may be set up. It can be custom config-
ured to meet your needs.
active arming
You can arm the system by pressing
of your 2-way remote
for one second. When the system arms, from the vehicle you will
hear a short siren sound, or chirp, and see the parking lights flash
once. If the power door locks are controlled by the system, the
doors will also lock. While the system is armed, the in-vehicle’s
status LED will flash approximately once per second, indicating
that the system is actively protecting your vehicle. If you hear a
➜
