ClimaCheck Gateway NX400 Hardware Manual
–
2020-03-26 Page 35 of 41
5
External switches and connections
The chapter describes the external connections and DIP-switches on the ClimaCheck Gateway
NX400. For a full description please refer to the supplier manual RTCU-NX400.
5.1
Analog Input Mode selection switches (mA/V)
To change the analog inputs on the Gateway between current and voltage input dipswitches on the
back side of the unit is used, see Figure 25.
Figure 25 Back side view
The red DIP-switch block to the right controls analog input 1 to 4 where OFF means voltage input
(0-10V) and ON means current input (0-20mA), see Figure 26.
Figure 26 Analog input DIP-switch
5.2
Network interface selection switch
To select network interface between LAN, WiFi and mobile DIP-switch 1 and 2 on the top left side
can be used, see Figure 27. The DIP-switch is only active if the setting under Network interface on
the Network Setup menu in the internal application is set to Use DIP-Switches, see section 3.11.
Figure 27 DIP-switches for communication
The DIP switches can be set as shown in Figure 28.