2
2. Introduction
2.1
Depending on the power cord fitted this fan heater may be used in certain
locations such as households, warehouses and workshops, building sites or
greenhouses. It incorporates a thermostat and a self-resetting thermal cut-out to
control the heating elements. The thermostat detects the air temperature and
controls the heat output of the appliance. The fan motor is not controlled by this
thermostat and it continues working when the thermostat switches off the heating
element. The self-resetting thermal cut-out will switch off the heater to prevent
overheating.
There is an additional thermostat to control the fan motor. If the
temperature inside heater is high, and the heater is connected to the power supply,
the thermostat may cause the fan to continue to run independently of the heat
selector dial setting. For example, after heating operation, when the heater is
turned off, the fan motor will continue to operate to reduce the temperature inside
the unit.
2.2
When using the heater for the first time, you may notice a slight emission of
smoke. This is quite normal and it will stop after a short time. The heating element
is made of stainless steel which was coated with a protective oil during
manufacturing. The smoke is caused by the residual protective oil when the heater
is switched on for the first time.
3.
Technical specifications
Model
HCK-TP15
HCK-TP30
Voltage
380-400V
380-400V
Required power
15000W
30000W
Current
21.7-22.8A
43.3-45.6A
Setting
110/5000/10000/15000W
70/15000/30000W
Self-resetting Thermostat
65°C
80°C
Product Dimensions (mm)
495X520X860
645X565X860
Net Weight (kg)
21.7
31.2
3.1
Housing made of heat-resistant powder coated steel plate.
3.2
Supplied with industrial socket installed in the heater. A 3-Phase cable (not
included) of the correct rating fitted with a suitable connector is required to connect
the HCK-TP15 and HCK-TP30 to the power supply.
