MatrixMonitor™ IOM - Rev 4 - 4/11/2013
Page 30
Supply : Life 100
Last Grease: 10/28/12
+ Resets Grease Life
Enter to Continue
The date on the second line will be todays date. If it is not, the real time clock is not set
properly. That must be done before you can use the grease life timer. Leave the reset
screen by pressing the
(enter) key twice and returning to the “
Control set Up
” sub
menu. Follow the instructions in the section “Set the real time clock” and start over.
Press the
(enter) key and the reset screen for fan array 2 will display.
Return : Life 45
Last Grease: 12/15/11
+ Resets Grease Life
Enter to Continue
The label on the first line before the colon is the array name label and it will correspond
to the name set up for array 2. The second line displays the last reset date for array 2. If
the screen does not look like the above the grease life timer has not been started for
array 2 and you are in the grease timer startup mode. Jump to “Starting the Grease Life
Timer” above if this is the case.
If you intend to reset the timer for fan array 2 press the “+” key, the grease life timer for
array 1 will reset and the following screen will appear to confirm this:
Return :
Has been reset or
enabled. Press any
key to continue. . .
If you did not want to reset the timer for array 2 then pressing the
(enter) key will skip
the screen above and return to the “
Control Set Up
” sub menu.
Assuming you reset the grease life timer for array 2 and are looking at the screen
directly above, pressing any key you will get the following screen:
Supply : Life 100
Last Grease: 10/28/12
+ Resets Grease Life
Enter to Continue
The date on the second line will be todays date. If it is not, the real time clock is not set
properly. That must be done before you can use the grease life timer. Leave the reset
screen by pressing the
(return) key and return to the “
Control set Up
” sub menu.
Follow the instructions in the section “Set the real time clock” and start over. If the date
is correct you have successfully reset the grease life timer for array 2. Press the
(enter) key to return to the “
Control set Up
” sub menu.
