1
Door Contact / Shock Sensor (DCSV-29)
DCSV-29 is a Door Contact / Shock Sensor that is capable of sending wireless signals to the Control Panel upon
detection of door/window opening or window glass break & shock detection.
The Door Contact / Shock Sensor design consists of a cover and base. The cover contains all electronics and the
base provides a means for fixing the device. An enclosed PCB tamper switch provides tamper protection against
unauthorized device opening and/or removal.
Parts Identification
1. LED Indicator / Test Button
- Press the button once to send a learn code or enter test mode for 3 minutes.
2. Cover Fixing Screw
3. Mounting Holes
4. Tamper Switch
- Provides tamper protection against unauthorized device opening and/or
removal from mounting surface.
5. Battery Insulator
6. Battery Compartment
7. Magnet
8. Magnet Screw hole
9. Magnet Spacer
Features
LED Indicator
In Normal Operation Mode, the LED will not light up when the device is activated.
When the device battery voltage is low, the LED will flash quickly when the device
is triggered.
When the tamper switch is triggered, the LED will flash quickly. When a tamper
condition persists, the LED will flash quickly whenever the device is triggered.
When under Test mode, the LED will flash quickly every time the device is
triggered.
When the battery is exhausted, the LED will flash every 4 seconds.
The LED will not flash if the device tamper and battery are normal and is not
under test mode.
If the LED flashes to indicate signal transmission, it will flash twice rapidly upon
receiving acknowledgement from panel.
Door Opening Detection & Shock Detection
The device is triggered by door/window opening or a shock detection which
exceeds detection threshold.
Materials of Mounting Surface
The device supports shock detection on various materials including glass,
wood, metal, and concrete. After installation, you can select the material of mounted surface on the Control
Panel.
Sensitivity
The sensitivity required to activate the Door Contact / Shock Sensor is determined from the Control
Panel.
Three sensitivity levels are selectable:
Low
,
Medium
, and
High
. The default is set as
Medium
.
Battery
The Door Contact / Shock Sensor uses one CR123 3V Lithium battery as its power source. The battery
