2
The backlight will turn on for 10 sec when any key (except Off/Home/Away key) is pressed. When the Off/Home/Away
key is pressed, the backlight remains off.
Power
Remote keypad uses one CR123 3V Lithium battery as its power source.
Remote keypad can also detect the battery status. If the battery voltage is low, the Low battery signal will be sent to the
Control Panel for displaying the status accordingly.
Before shipment, the battery is pre-installed by the factory.
When changing battery, press any key a couple times to discharge before inserting new battery.
<WARNING>
The polarity of the battery must be observed.
Only use specified battery with the keypad. Improper use or handling of lithium battery may result in heat
generation, fire or explosion, which may lead to personal injuries.
Dispose of used battery according to the instructions.
Operating Temperature & Humidity
Operating Temperature: -10
°
C ~ 50
°
C
Humidity: Up to 85% relative humidity @23
°
C
Tamper Protection
The keypad is protected against any attempt to open the lid or to detach keypad from its mounting surface.
Tamper protection is disabled when the keypad is in Test Mode.
Getting Started
A. The Keypad has never been learned into a Control Panel (First Time Learning)
Step 1. Put the Control panel into learning mode.
Step 2. Power on the keypad by removing the battery insulator, the Remote keypad will automatically send a learn
code to the Control Panel.
Step 3. During learning process, the power LED will flash for 10 times.
Step 4. If the Control Panel receives the learning code, it will display the info accordingly. Refer to the operation
manual of your Control Panel to complete the learn-in process.
Step 5. The Keypad will emit 3 beeps when learning is successful.
B. The Keypad has been previously learned into a Control Panel (Re-learn into a new Control Panel)
Step 1. Put the Control panel into learning mode.
Step 2. Put the Keypad into test mode. (Refer to
Test Mode
section.)
Press
“Cancel” key and 7 to send a learning code to the Control Panel. Remote keypad will sound a long beep.
Step 3. During learning process, the power LED will flash for 10 times.
Step 4. If the Control Panel receives the learning code, it will display the info accordingly. Refer to the operation
manual of your Control Panel to complete the learn-in process.
Step 5. The Keypad will emit 3 beeps when learning is successful.
After the Remote keypad is learnt-in, press any key under normal operation mode to send a key value to the Control
Panel to confirm this location is within the signal range of the Control Panel. (If the keypad is still in test mode, please
leave test mode by pressing the Away key twice.)
When you are satisfied that the Remote keypad works in the chosen location, you can proceed with mounting the
Remote keypad following the steps described below (please refer to
“
Mounting Remote keypad
” for details)
.
Test Mode
To enter test mode
:
1) Press and hold the
“Enter”
key while powering on the remote keypad by inserting the CR123 3V Lithium battery.
Keep holding the
“Enter”
key and don
’t release it until the backlight turns on with two beeps.
2) Within 30 seconds put remote keypad in Test mode by entering keypad PIN code (default:
0000
), then press the
“Cancel” key.
3) The three
Off/Home/Away LEDs will turn on along with a long beep.
<NOTE>
If keypad PIN code is entered incorrectly, Fault LED (Orange LED) will flash 4 times along with 4 beeps.
