3
Safety Box Installation:
When mounting on Safety Box, mount the Sensor no more than 2cm away from the door pivot.
2. Clean and dry the mounting location. Do not install on dirty or web surface.
3. Use the provided double-sided adhesive tape (
Ø35mm x 8mm
) to apply to the back cover of
SVGS and stick the sensor onto the mounting location.
<NOTE>
Please do not apply the double-sided adhesive tape to the front cover where Test Button
and LED indicator are located, and do not apply the tape twice.
Installation Guideline
Always make sure to test detection range after installation to confirm the actual detection range.
The adhesive tape may lose its stickiness over time. Make sure to check the sensor at least once every 6 months.
Avoid mounting at location prone to strong wind that could dislocate the Sensor.
Avoid mounting at location prone to shaking or vibration, which will cause false alarm.
Set the Sensor to low sensitivity when installing on movable windows to prevent false alarming.
Avoid mounting at location where the Sensor could easily collide with object.
When mounting on plywood:
1 Use only high sensitivity setting.
2 Mounting on wall next to large furniture may affect the sensor’s detection range and signal transmission range.
Make sure to test the sensor if choose to mount at such location.
Sensor detection range is affected by adhesive tape size and material. The sensitivity-range table provided in this
document is tested with factory provided adhesive tape. If different adhesive tape is used, make sure to retest the
detection range.
