41
fall detection (of a Fall Sensor) has its
own
timer
(programmed
using
Command 66). The CTC-1052-QT-
DT35AW will play voice prompt “A fall
has been detected,” to notify the user;
and “Fall detection has restored,
cancelling help call” voice prompt,
when fall detection has been cancelled.
Confirmation Voice Prompt
After Guard Time expires, CTC-1052-
QT-DT35AW will summon help based
on the programmed reporting method.
The Control Panel will play a voice
prompt “Emergency call in progress” to
indicate that the call is in progress.
The Control Panel will play voice prompt
during the following situations:
After the Control Panel dials out to
summon help and until handshake (for
Digital Reporting Method).
After the Control Panel dials out to
summon help and until the call is
answered (for Speech Reporting
Method).
When the first reporting failed, and the
Control Panel retries.
The
Control
Panel
stops
playing
confirmation voice prompts once the first
reporting succeeded and Control Panel is in
the process of back-up reporting.
5.2.1. GPRS Reporting Method
Please program GPRS Report settings via
SMS Remote Programming Commands for
GPRS Reporting Methods. Below are the
settings required for GPRS reporting:
Access Point Name (APN):
the name of
an access point for GPRS. Please inquire
your SIM card service provider for your
APN.
User Name:
offered by your SIM card
service provider.
Please inquire your
service provider for your GPRS username.
If no username is required, you may skip
this step.
Password:
offered by your SIM card
service provider.
Please inquire your
service provider for your GPRS password.
If no Password is required, you may skip
this step.
IP Address:
Central Monitoring Station
server IP. Please refer to
4.3.1
1052-QT-
DT35AW SMS Remote Programming
Table
on how to set CMS IP Address(es)
(SMS Commands: TCIP1 and TCIP2).
Port Number:
Central Monitoring Station
server port number. Please refer to
4.3.1
1052-QT-DT35AW
SMS
Remote
Programming Table
on how to set Port
Number(s) (SMS Commands: PORT1 and
PORT2).
GPRS/IP Account Number:
There are 2
account numbers available for GPRS/IP
reporting. Please refer to
4.3.1
1052-QT-
DT35AW SMS Remote Programming
Table
on how to set GPRS/IP Account
Number(s) (SMS Commands: IPAC1 and
IPAC2).
To disable GPRS Reporting Method:
by
removing the IP address, GPRS reporting
becomes ineffective. Proceed to SMS
Remote Programming and send in this
format:
“
PROG 1111 TCIP1:
”
Where:
PROG
= SMS Keyword
1111
= Access Code
TCIP1
= SMS command for IP Address (no
input value means deletion of characters)
5.2.2. SMS CID Reporting Method
If SMS CID reporting is selected, the event
codes will be sent in the form of a SMS
message to the reporting destination.
Post-Digital-Alarm Operation
After a successful report, CTC-1052-QT-
DT35AW will then follow the choice of
Command #38, to enter
Call-Back or
Follow-On & Call-Back
mode.
Call-Back Operation
If Command #38 is set as Call-Back
(1)
or
Follow-On & Call-Back
(2)
after alarm
reporting, it will then wait 5 minutes for
Monitoring Center Personnel to call-back
after reporting.
<NOTE>
