22
4.4 PC Programming Mode
The 1052-QT-DT35A-Tool is a programming software that provides intuitive graphical interface for
you to program the panel easily from your computer, instead of entering complex DTMF commands
from your phone or sending complex SMS text messages from a mobile device.
System Requirement:
Microsoft Windows 7, Windows 8 or Windows 10 operating system
USB Serial Port supported.
To enter PC programming mode:
Panel Connection
Step 1.
Plug a DC 12V 1A power adapter into the DC Jack of your panel and connect to power
supply. Press the power button to power on the panel.
Step 2.
Plug the PC Programming cable into the Programming Telephone Jack of the panel.
Step 3.
Connect the PC Programming cable to the USB Extension Cable.
Step 4.
Connect the USB Extension Cable to the USB port on your computer.
See
Figure 1
for connection diagram between medical panel and computer.
See
Figure 2
for CTC-1052-QT-DT35AW connection jack locations.
Figure 1
Figure 2
Installing The USB Driver
Step 5.
For the computer to recognize the USB connection, please try installing the USB driver.
Please go to
http://www.ftdichip.com/Drivers/VCP.htm
. Scroll down the webpage and select
the driver file according to your operation system, download and install the driver.
