5
3. Remove the Devices
There are two methods to remove learned-in
devices:
command removing
,
local removing
,
and
SMS command removing.
3.1. Command Removing
Command Removing
The user can use Commands 80-82 to remove
learned-in devices from the system.
1.
Command 80
is used to remove
ALL
previously learnt-in devices.
2.
Command 81
is used to remove
Zone 1
device.
3.
Command 82
is used to remove
Zone 2
device.
Please refer to
4.2 Programming Your 1052-
QT-DT35AW: Commands 80-82
for details.
The PC Programming Tool (1052-QT-DT35A-
Tool) also supports
Command Removing
.
Please refer to
4.4 PC Programming Mode
4.4.1.5 Device
for detailed instructions.
3.2. Local Removing
Under Local Learning Mode, the devices
learnt into Zone 1 and Zone 2 can be
removed by pressing and holding the Learn
Button for 6 seconds.
CTC-1052-QT-DT35AW will emit one long
beep to indicate that the devices in Zone 1
and Zone 2 are removed.
3.3. SMS Command Removing
SMS Command Removing
The user can use the SMS command DEVDL
to remove all learned-in devices from the
system. Please refer to the table
CTC-1052-
QT-DT35AW SMS Remote Programming
Command Table
for details.
4. System Configuration
Three CTC-1052-QT-DT35AW programming
modes are available: Remote Programming
Mode,
SMS
programming,
and
PC
Programming Mode.
4.1. Remote Programming
Mode
To allow Remote Programming, there are two
options for CTC-1052-QT-DT35AW to answer
the incoming calls.
(1) Auto Answering by ring count
(2) Dial in twice (Ring Count disable)
The two options are set by Command #41.
Please refer to
Command 41
under section
4.2
Programming Your CTC-1052-QT-DT35AW
4.1.1. Auto Answering by Ring Count
By using Command 41, you can set the number
of rings for CTC-1052-QT-DT35AW to answer
(00-Rings is set as factory default).
Step 1.
Dial CTC-1052-QT-DT35AW and wait
for CTC-1052-QT-DT35AW to answer.
Step 2.
Enter 1111 (default 4-digit Access
Code) followed by #, via the phone set.
Step 3.
CTC-1052-QT-DT35AW will respond
with two quick beeps to indicate it is
ready for Remote Programming.
Step 4.
You are now in Programming Mode.
Proceed to program by referring to the
Command in section
4.2 Programming
Your TC-1052-QT-DT35AW
.
4.1.2. Dial in Twice (Ring Count Disable)
As
00
is set in Command 41 by default, it means
CTC-1052-QT-DT35AW is disabled to auto
answer the incoming calls by ring count. If
Remote programming is required, you will need
to call CTC-1052-QT-DT35AW twice.
Step 1.
Dial CTC-1052-QT-DT35AW and hang
up after first 2 rings, wait for another 8-
20 sec then call again. CTC-1052-QT-
DT35AW will answer the call on the first
ring. You will enter the Remote
Programming Mode after the first ring
from the 2nd call.
