6
Step 2.
Enter
1111
(the default 4-digit Access
Code) followed by #, via the phone set.
Step 3.
CTC-1052-QT-DT35AW will respond
with two quick beeps to indicate it is
ready for Remote Programming
Commands.
Step 4.
You are now in Programming Mode.
Proceed to program by referring to the
Command in section
4.2 Programming
Your CTC-1052-QT-DT35AW
.
<NOTE>
The first digit of Access Code must be
entered within 15 seconds; otherwise
CTC-1052-QT-DT35AW
will
exit
automatically.
To exit Remote Programming mode,
enter 99 followed by #.
4.2. Programming Your 1052-
QT-DT35AW
How to enter Commands?
Please make sure CTC-1052-QT-DT35AW is
in Programming Mode before trying any
CTC-1052-QT-DT35AW Command Functions.
Please
refer
to
section
System
Configuration, Entering Programming Mode
.
Follow the protocol below to command
CTC-1052-QT-DT35AW:
1.
CC
= 2-digit DTMF Command
2.
#
=
Termination of the DTMF Command
3.
ACK
=
DTMF Command
Acknowledgement
On CTC-1052-QT-DT35AW:
Short beep: Command succeeded
Long beep: Command failed
On the programming phone set:
Short beep: Command succeeded
Long beep: Command failed
4.
Function Selection
= According to different
Command you will have different entering in
this part, e.g. Tel. Number, Account number,
etc.
5.
# =
Terminates Function Selection
6.
ACK
= Function Selection
Acknowledgement
On CTC-1052-QT-DT35AW:
Short beep: Command succeeded
Long beep: Command failed
On the programming phone set:
Short beep: Command succeeded
Long beep: Command failed
Follow the Command Steps to program
your CTC-1052-QT-DT35AW:
Step 1.
Enter Command number (DTMF
Numeric Command, ex. (
01
), (
02
)…)
Step 2.
Press (
#
) to terminate the DTMF
Command.
Step 3.
One short beep will be heard for
successful Command entry.
Step 4.
Enter the desired Command function
number.
Step 5.
Enter (
#
) to terminate the Command
Operation.
Step 6.
CTC-1052-QT-DT35AW will emit a
short beep, indicating successful
programming.
The maximum interval between key strokes is 2
minutes
.
Otherwise, commands will be ignored
and CTC-1052-QT-DT35AW will automatically
exit to Idle Mode.
Any erroneous programming must be
rectified and program again correctly.
Command 00
Caller ID
Command (
00
) can be used to program 20
Caller ID(s).
CC # DTMF
ACK
Function
Selection
# DTMF
ACK
1. 2.
3.
4.
5.
6.
