5. Device Management
The Device Management section allows you to learn in, edit, control and view all available
accessory devices that can be included in the HSGW Control Panel.
5.1. Learning
Use this function to add new devices into the Control Panel. HSGW supports up to 160 zones of
accessory devices, in 2 areas, up to 80 zones each area.
The following types of accessory devices are supported:
RF device:
All Climax RF devices are supported. (For ZigBee only model, RF devices are
not supported.)
ZigBee device:
All ZigBee device with ZigBee Home Automation 1.2 profile are supported.
<IMPORTANT NOTE>
The Control Panel built-in ZigBee module supports up to
40
ZigBee devices by itself. If
you wish to include more than 40 ZigBee devices into the Control Panel, you must add
extra ZigBee Routers into the Control Panel’s ZigBee network to increase the network’s
maximum device capacity.
IP Cameras:
The Control Panel is compatible with Climax VST-1818 Series IP Camera. Up
to 6 IP Cameras are supported.
Z-Wave Device:
Available for Z-Wave modules only, other modules requires additional
USB Z-Wave Dongle.
5.1.1. Add Sensor
Step 1.
Click on “
Learning
” to enter learn page.
Step 2.
Click on “
Start
” to enter learning mode.
Step 3.
Press the test or learn button on the each device or any button on the Remote
Controller. (Please refer to each sensor’s user manual for test or learn button position).
<NOTE>
For ZigBee sensors, press and hold the learn button for 10~12 seconds to transmit a
15
