<NOTE>
The Device Edit page is only available for the newest BX/Siren series and BX series
without DIP Switch
.
Edit your Siren setting and information accordingly to instruction below. Click “
OK
” to save your
new changes when finished. Alternatively, click “
Default
” to reset all parameters to default
values or click “
Reset
” to re-enter all the information.
Name:
Enter a name for the Siren.
Area:
Select the area which the Siren belongs to.
Zone:
Select the Siren zone number.
Attribute:
Permanently Bypass:
If checked, the Control Panel will completely ignore all signal
received from the Siren. A bypassed Siren will not be able to trigger any response,
including alarm or fault from the Control Panel. All other attribute settings will also be
ignored.
Whole Area:
if checked, all the Volume, Voice and Behavior functions will be
simultaneously enabled in Area 1 and Area 2.
Volume:
Alarm Sound:
set the volume of the alarm sound of the Siren when alarming.
Full arm confirm beep:
set the volume of the confirm beep sound of the Siren when
33
