6. Program the System
After the initial set-up, you can then program your system by clicking on the left menu to set
them individually.
6.1. Panel Condition
In the
Panel
Section, user can arm, disarm or partially arm the system. Besides, it displays the
current
Panel Status
&
Device Information
.
Panel Control
Select a choice to arm, disarm or partially arm the system.
Panel Status
The Control Panel will update the panel status periodically. However, in order to show the
current status, you must reload the screen to refresh the display.
Battery
: When battery is running low, a “low battery” message will be displayed to
inform you to recharge the battery.
Tamper
: (reserved)
Interference:
This is for you to check whether the Control Panel is purposely interfered.
The jamming period detected will be accumulated, and when the total period exceeds
30 seconds within 1 minute, a “Jamming
”
message will be shown and reported to the
Central Monitoring Station accordingly.
AC activation
: To check whether AC power is connected. If not, it will show “AC
Failure”.
Background RSSI
: Rssi value is for you to check the RF environment around the
36
