3. Getting Started
Read this section of the manual to learn how to set up your Control Panel and program System
Settings over the Web page.
3.1. System Deployment
Follow guidelines below when planning installation location:
The Control Panel requires Ethernet connection.
The Control Panel should be installed at a location that is hidden from outside view.
Avoid mounting the Control Panel near large metal objects which may affect wireless radio
strength.
The Control Panel should be protected by sensors so that no intruder can reach the Control
Panel without first activating a sensor.
When using
ZigBee routers
to improve ZigBee network coverage, remember to use only
ZigBee Router with backup batteries for security sensors. If you use a Router without
backup battery for security sensors, the Router will be powered down in case of AC failure,
and you security sensors will lose connection with the ZigBee network.
Home Automation devices (Power Switches…etc) do not have this limit and can be used
with any Router.
3.2. Hardware Installation
The panel can be either fixed on the wall or placed on deskop. Remove the bottom standing
base to reveal the bottom cover fixing screw. (Figure 1)
1
(Case Version A for example) The panel casing is secured by 4 screws, 2 at top and 2 at
bottom, remove the top 2 screws and loosen the bottom 2 screws. (Figure 2)
Figure 1 Figure 2
7
