6.3. PIN Code
The User PIN Codes are used by Remote Keypad accessory to control system mode remotely.
The 2 areas in the control panel have 60 User PIN Codes available for setting. Each consists of
4-6 digits (numeric number 0~9), no disallowed PIN code. User PIN code #1 is always activated
factory default.
User PIN #1 in Area 1, 2
Password:
1234
User Code Setting
User Code
: Enter the 4-digit code in the field.
Tag Number
: The number indicates the tag which is associated to the user code. By
applying a tag to the tag sensor zone of Remote Keypad and clicking the
Load
button,
the corresponding tag number will be loaded.
Area
: Select the area for setting User PIN Code.
User Name
:
Enter a user name for easy recognition of system events. Up to 17
alphanumerical characters are allow for each user name.
Latch
:
Latch
Latch Report ON
= Whenever the User PIN Code is used to change
system mode, the panel will report the event.
Latch
Latch Report OFF
= When the User PIN Code is used to change system
mode, the panel will not report the event.
Delete
:
Check the box if you want to delete selected user. User#1 in each area cannot
be deleted
After finish all setting, click
OK
to confirm change.
43
