5
If Repeater B receives the learn code from Repeater A, it will emit 1 long beep and the Blue
LED will light up for 1 second to indicate successful learning.
If Repeater B receives the learn code from Repeater A and Repeater A was already learnt,
Repeater B will emit 2 beeps and the Blue LED will light up for 1 second.
<NOTE>
Please do not cross-learn the Repeaters, e.g. Learning Repeater A into Repeater B and
learning Repeater B into Repeater A.
All repeaters will have to be learnt into the Control Panel.
Step 3
When the learning is complete, slide DIP Switch 1 of Repeater B to the Off position.
Repeater B will emit 1 long beep and the Yellow LED will turn off as Repeater B returns to
Normal Mode.
Learning Device into Repeater
Step 1
Under Normal Mode, slide DIP Switch 1 to the On position. The Repeater will emit 1 long
beep and the Yellow LED will flash slowly (1 flash every 2 seconds).
Step 2
Please refer to the device manuals on how to send learn code from the devices.
For PIR Camera, please press the test button once to send a learn code to the
Repeater.
If the Repeater receives a learn code from a new device, it will emit 1 long beep and the
Blue LED will light up for 1 second to indicate successful learning.
If the Repeater receives a learn code from a device already learnt into the Repeater, it will
emit 2 beeps and the Blue LED will light up for 1 second.
A maximum of 60 devices (including repeaters) can be learnt into the Repeater, and
up to 8 PIR cameras are supported. If the user attempts to learn in a 61
st
device, the
Repeater will emit 4 beeps.
<NOTE>
If multiple repeaters are used, please only learn devices into the Repeater(s) closest to the
operation areas of the devices.
All the devices learnt into the Repeater must also be learnt into the Control Panel.
Step 3
When the learning is complete, slide DIP Switch 1 to the Off position. The Repeater will emit
1 long beep, the Yellow LED will turn off as the Repeater returns to Normal Mode.
Walk Test Mode
Learnt-in Control Panel or learnt-in devices can check for its signal range with the Repeater if the
Repeater enters Walk Test Mode.
