CLIMIA CTK 240, Operating Manual

9

CTK 240 mobile air dehumidifier

8.0 Set-up

For the best economic and safe use 
of the units, the following notes 
must be followed in full: 

•

   The units must be set up in an 

upright and level position, to 
ensure that the condensate can 
drain freely 

•

   To ensure optimum air 

circulation, the units should be 
set up in the centre of the room, 
where possible 

•

   Ensure that the room air can 

be sucked in and discharged 
without hindrances

•

   Observe a minimum clearance of 

50 cm from walls at all times

•

   Units must never be set up in the 

immediate vicinity of heaters or 
other sources of heat

•

   Air circulation is improved if the 

unit is set up approx. 1 m above 
the ground 

•

   The room being dried or 

dehumidified must be closed to 
the surrounding atmosphere

•

   Avoid having opened windows 

and doors etc., and avoid 
frequent entry to or exit from the 
room as much as possible

•

   The units may not be used in 

environments containing a 
great deal of dust or chlorine, 
or in places with atmospheres 
containing ammonia 

•

   The output of the unit is 

entirely dependent on the 
conditions inside the room, room 
temperature, relative humidity 
and observance of the set-up 
instructions

Min. 0.5 m 

distance to wall

Maintain adequate clearance from 

heaters or other sources of heat.

Keep windo

ws and do

ors closed!

Fig. 2

Schematic depiction of how to set up the air dehumidifier

9.0 Commissioning

Before commissioning the unit or if 
local requirements dictate, the air-
inlet grill and air-outlet grill must be 
checked for contamination.

Important notes prior to 

commissioning 

•

   All extensions to the electrical 

connection must be of 
a sufficient cable size and must 
only be used fully rolled out or 
unrolled

•

   Never use the power supply 

connection cable as a pull cord 

•

   After being switched on, 

the units operate fully-
automatically until switched off 
by the hygrostat or float when 
the condensate container is full 

•

   The condensate container must 

be inserted properly 

The unit cannot be operated 

if the condensate container 

is not inserted properly!

•

   In order to prevent damage to 

the condenser, the units are 
equipped with a mechanism that 
prevents the compressor being 
immediately switched back on 
after it is switched off 

The units do not switch back 

on until a waiting time of 

around 3 minutes has elapsed!

•

   If the units work in continuous 

operation with an external 
condensate drainage 
connection, refer to the relevant 
section

NOTE

A contaminated grille or filter 

must be cleaned or replaced 

immediately.