Page 6 of 11
Tool Preparation:
The tool must be connected to an air filter. This unit filters the compressed air to separate dirt
and condensate. A pressure regulator with a preferred setting of 87 psi must be installed. Air
supply must be free of moisture and particles.
Use dry and clean materials (hose, couplings, fittings, etc.) to connect the tool to the filter.
Check for leakage in the compressed air supply. If here is leakage, replace the damaged hoses
or coupling. Drain the condensate from the filter. Also check the dirt filter.
Check the compressed air supply pressure. The tool must be fitted with correct nosepiece (01)
and pusher (07) before operating.
