--15 --
The unit has a “strange” behavior:
An important parameter may have been changed by accident.
1.
Make notes about your parameter setups.
2.
Proceed a “MASTER RESET” (see MASTER RESET
instruction)
3.
Test the machine for proper function.
4.
Reprogram the machine step by step to your original setup.
5.
Please remember to check the positions and the direction
carefully before you start the machine.
The motor gets too hot:
1.
Go to the SYSTEM TEST and check the balance of the motor
see the manual for “ system test instruction”
2.
Check the machine head. The machine head should turn
freely.
The position stop points are not matching correctly with the adjustment made with
the “teach-in” mode:
Please return back to the parameter and make the final
adjustments in small increments with the ARROW UP / DOWN
button.
Don’t use the “TEACH-IN” mode to change small amounts.
The position is erratic and/or migrating:
3.
Go to the “SYSTEM TEST” routine and test the balance of
the motor.
4.
Make sure, the position point is slightly before the top center.
5.
Check the LOVEJOY coupling at the motor and machine
shaft for proper tightness.
