CLIVET ELFOROOM 11 Installation And Maintenance Manual Download

Page: 80 / 264

7 - MAINTENANCE

7.8 TABLE OF ANOMALIES AND REMEDIES

Effect

Cause

Remedy

The coil does not reach a uniform
temperature.

Air present in the inner circuit of the
appliance.

Release the air several times

A delayed activation of the ventilation
respect to the new temperature or function
settings.

The circuit valve needs some time to open
and as a result the hot or cold water takes
time to circulate in the appliance.

Wait for 2 or 3 minutes to open the circuit
valve.

The ventilation speed increases or
decreases automatically.

The electronic control adjusts the comfort
level regularly.

Wait for the temperature adjustment or in
case of necessity select the silent function.

The appliance does not activate the
ventilation.

No hot or cold water in the system.

Check that the water boiler or cooler are
functioning correctly.

The ventilation does not activate even if
there is hot or cold water in the hydraulic
circuit.

The hydraulic valve remains closed.

Dismount the valve body and check if the
water circulation is restored. Check the
working efficiency of the valve by powering
it separately with 220V. If it activates the
problem could be the electronic control.

the fan motor is blocked or burnt out.

Check the windings of the motor and the
free rotation of the fan.

the micro-switch that stops the ventilation
when the filter grill is opened does not close
correctly.

Check that by closing the grill the
microswitch contact is activated.

the electrical connections are not correct.

Check the electrical connections.

The appliance leaks water during the
heating function.

Leaks in the hydraulic connections of the
system.

Check the leak and fully tighten the
connections.

Leaks in the valve unit.

Check the state of the gaskets.

There are formations of dew on the front
panel.

The thermostatic valve built into the
connection unit between plate and battery
does not close the flow towards the wall.

Replace the union that joins the
thermostatic valve to the water inlet upper
unit.

Thermal insulation unstuck.

Check the correct positioning of the
thermo-acoustic insulation paying attention
to that in the front above the finned
battery.

There are drops of water on the air outlet
grill.

In situations of high humidity (>60%)
condensation could form, especially at the
minimum ventilation speeds.

As soon as the humidity starts falling the
phenomenon disappears. In any case the
presence of a few drops of water in the
appliance does not indicate a malfunction.

The appliance leaks water only during the
cooling function.

The condensation bowl is blocked.
The condensation discharge does not need
an inclination for correct drainage.

Slowly pour a bottle of water in the low
part of the battery to check the drainage; if
necessary, clean the bowl and/or increase
the inclination of the drainage pipe.

The connection pipes and the valve unit are
not insulated well.

Check the insulation of the pipes.

The appliance makes a strange noise.

The fan touches the structure.

Check for any interference by manually
rotating the fan.

The fan is unbalanced.

The unbalancing causes excessive
vibrations of the machine; replace the fan.

All the LEDs flash at the same time.

Dirty filters.

Clean the filters and reset the signal by
pressing the MODE key for at least 5
seconds.

The interventions must be carried out by a qualified installer or by a specialised service centre.