10 |
EN
EN
| 11
Volts
~115V
Running AMPS
6.0
Startup AMPS
14.6
Frequency
60 Hz
Standard Hose Length
7 ft. (2.13 m)
Dimensions
25 3/8 in. (64 cm) H x 10 1/16 in.
(26 cm) W x 17 1/8 in. (43 cm) L
Air Line Pressure
35 psi (2.4 Bar)
Weight – Empty
43 lbs (20 kg)
Weight – Full
59 lbs (27 kg)
Shipping Weight
52 lbs (24 kg)
Flow Rate
4.3 oz./min (130ml/min)
Volts
~240V
Running AMPS
3.0
Startup AMPS
7.0
Frequency
50 Hz
Standard Hose Length
7 ft. (2.13m)
Dimensions
29.25 in. (0.74m) H x 10.00 in. (0.25m)
W x 16.00 in. (0.40m) D
Air Line Pressure
35 psi (2.4 Bar)
Weight – Empty
43 lbs (20 kg)
Weight – Full
59 lbs (27 kg)
Shipping Weight
52 lbs (24 kg)
Flow Rate
4.3 oz./min (130ml/min)
Excessive nozzle dripping
Potential Issue
Corrective Action
Damage to nozzle assembly
Inspect for damage and faulty
parts. If present, contact the
Clorox® Total 360® Electrostatic
Sprayer support center service
department.
Damage to peristaltic pump
tubing
Replace pump tubing.
Dirty exterior sprayer surfaces
Clean exterior surfaces with
solvent (70–90% alcohol).
System will not turn on or has shut off suddenly
Potential Issue
Corrective Action
No power
Verify the unit is plugged
in and on a known working
power outlet.
System is not switched on
Depress power switch
to illuminate.
Compressor shuts off suddenly
or won’t run while depressing
the sprayer trigger
This is a sign that the unit’s
circuit breaker has tripped
or that the compressor has
overheated. The user should
look to see if the white button
(within its clear moisture cover)
has popped out. If it has, the
user should power off the
machine, look for any physical
objects that could be loose or
stuck in any of the ventilation
openings and clear/dislodge.
Press the button in and then
attempt to power the unit back
on. If the problem persists,
the user should let the unit sit
for 30 minutes to see if it’s an
overheating issue. If the unit
still refuses to restart after a
cool down, then the user should
contact technical service.
Compressor has overheated
Allow the unit to sit for a
minimum of 30 minutes
with the power off.
Unit stalls at initial trigger
This may be a sign of a cold
start. Warm unit up by pressing
the trigger and letting unit run
for up to two minutes.
Trigger off, then on. Unit should
run normally.
No spray, erratic spray or weak spray
Potential Issue
Corrective Action
Out of liquid solution
Inspect product container
for solution level and replace
if empty.
Blockage in the nozzle
or liquid tip
Remove the nozzle cover
and/or liquid tip to inspect
for blockages.
Spray appears weak
The user should power the unit
off, unplug from the wall and
seek out a different electrical
outlet to try. If unavailable,
they should look to see if other
devices are running on the same
electrical circuit. Power those off
if necessary.
This could be a result of an
underrated extension cord. If an
extension cord is being used,
remove and test the unit while
using only the connected power
cord. See the extension cord
section for more information.
Damage to liquid hose
or peristaltic pump tubing
Inspect the liquid line for kinks
and/or damage.
Air pressure seems low or weak
Potential Issue
Corrective Action
Damage to the air hose
Inspect hose for knicks,
damage or areas where air
is escaping.
Blockage in the nozzle
Remove the nozzle cover
and inspect for blockages.
Clogged air filter
Replace air filter.
SPECIFICATIONS for 115V model
SPECIFICATIONS for 240V model
TROUBLESHOOTING
NOTE:
Do NOT use a chemical in the unit that is not a Clorox-
approved product. If you encounter the issues listed below, use the
suggested troubleshooting methods. If you encounter an issue that
is not addressed in this manual, contact Service Tech Team at
www.servicetechteam.com.
EQUIPMENT WARRANTY
Clorox warrants the original purchaser of any Clorox® Total 360®
Electrostatic Sprayer that the equipment shall be free from
defects, material and workmanship, for a period of one year after
the date of delivery.
Disclaimer of Implied Warranties and Consequential Damages
The Clorox obligation under this warranty, to the extent allowed
by law, is in lieu of all warranties, implied or expressed, including
implied warranties of merchantability and fitness for a particular
purpose and any liability for incidental and consequential damages
with respect to the sale or use of the items warranted.
Such incidental or consequential damages shall include, but are
not limited to: transportation, charges other than normal freight
charges, cost of installation other than cost approved by Clorox,
duty, taxes, charges for normal service or adjustments, loss of
income, expenses due to loss, damage, detention or delay in the
delivery of equipment or parts resulting from acts beyond the
control of Clorox.
THIS WARRANTY SHALL NOT APPLY TO:
1. Defects, failures, damages or performance limitations caused
in whole or in part by:
a. Power failures, surges, accidents, actions of third parties,
weather or other acts of God, or
b. The product being subjected to abuse, mishandling,
misuse, negligence, improper storage, service or operation,
or unauthorized attempts to repair or alter the equipment
in any way.
2. Any product in which any chemical other than chemical sold by
or on behalf of Clorox and expressly identified by Clorox for use
in such product.
3. Normal wear and tear.
NO EMPLOYEE OR REPRESENTATIVE OF CLOROX IS AUTHORIZED
TO CHANGE THIS WARRANTY IN ANY WAY OR GRANT ANY
OTHER WARRANTY UNLESS SUCH CHANGE IS MADE IN WRITING
AND IS SIGNED BY A CORPORATE OFFICER OF CLOROX.
