- 14 -
User’s Guide
Pan/Tilt Network Camera
Set up camera IP using Setup IP program
1. Characteristic and caution to Setup IP program
A.
Setup IP Software (Version 2.0.0.2) only operates in
Static IP set-up mode. In case the
camera has been set up in
Dynamic IP or/and
PPPoE mode, it is advised that the camera is
to be initialized to the Static IP using the factory Reset.
B.
If Camera Firmware is a year 2003 patched version it is recommended to update to year
2004 patched version or use Setup IP Software Version 1.0.
C.
Complete all settings within 5 minutes because item is deleted automatically in program list
If 5 minutes are passed after camera booting
D.
Check for User setting value
i.
Web Server Port (TCP): If not 80, it should be bigger than 1024 and smaller than 65535.
(Default: 80)
ii.
Video Server Port (TCP): If not 4333, it should be bigger than 1024 and smaller than
10000. (Default: 4333)
2.
Set-up procedure
A.
Download Setup IP Software when connecting
camera with PC Connect power and LAN into
camera
B.
Execute Setup IP downloaded in PC
C.
After camera booting (10 sec) MAC Address and
temporary IP of camera are marked in <Scan the
Pan/Tilt Network Camera> area on top of the
program
D.
If you click MAC Address, temporarily given
network information is marked in Setup IP portion
of program.
E.
Enter network information that you wish to set up
F.
If click [Apply] button, setting is completed.
3.
Setting method by Network Type
A.
Static IP
i.
Internet Address: Enter IP information given by internet service provider or network
manager.
ii.
Subnet Mask, Default Gateway: Subnet Mask, Default Gateway: Enter information that
is given with IP information. Generally it is identical with the value that is established in
PC.
