- 41 -
User’s Guide
Pan/Tilt Network Camera
Network
1.
TCP/IP
A.
Network Type
i.
Static IP
1.
Set up IP Address, Subnet Mask, Gateway and DNS Server given by internet service
provider (ISP) of network administrator. It is the same set-up as PC network installed
with camera.
2.
Set up Web Server Port and Video Server Port (Default: 80, 4333)
3.
Virtual IP Address: if you forget IP Address of camera, you can connect to emergency
connection IP Address used for emergency connection in local network
4.
Auto-Reboot Flag: it is an automatic rebooting function for having a problem in
network condition while camera started to run normally..
5.
Click [Apply] after setup.
ii.
Dynamic IP(Cable Modem, DHCP)
1.
Set up Web Server Port and Video Server Port
2.
Click [Apply] after setup.
3.
Automatic rebooting function can be applied when there is a problem in network
condition using Service
iii.
PPPoE(xDSL)
1.
User ID: Enter User ID issued by internet service provider (ISP)
A.
User ID must be in alphabet letters between 4 and 20.
B.
Use over 20 characters: maximum of 35 alphabet letters can be entered after checking.
2.
User Password: enter user password issued with ID by ISP ( between 4 and 20
characters)
3.
Enter Web Server Port and Video Server Port
4.
Click [Apply] after set-up is completed.
5.
Automatic rebooting function can be applied when there is a problem in network
condition using Service
Set
TCP/IP, then click [Apply] and then camera reboots automatically. (Time: 10sec)
