- 68 -
User’s Guide
Pan/Tilt Network Camera
C.
The bottom
i.
Dip Switch set-up
1.
Action Input: it
turns ON/OFF
the power of
Alarm I/O module
A.
ON: when not using the function of Action Input
B.
OFF: when using the function of Action Input (refer the below diagram)
2.
Exit Delay:
when surveillance mode (Sensor Enable) is set in camera, it runs Alarm
I/O Module after a certain period of time.
A.
ON: the module runs after a certain period of time. (Time delay: 120 seconds)
B.
OFF: the module runs without time delay.
3.
Entrance Delay:
it is a function that signals camera after certain period of time when
sensor connected to Alarm Input starts to work.
A.
ON: when sensor connected to Alarm Input starts to work, it sends a signal to
camera after 30 seconds and then begins interlocked Preset, Alert Sound, E-mail
(record file attached) as set.
B.
OFF: when sensor connected to Alarm Input starts to work; it sends a signal to
camera immediately and begins to interlocked actions.
4.
Invert #1, #2: set up a switch in the input terminal according to type of sensor
(N.C/N.O)
A.
Invert Switch Setting
Sensor Type
Invert Switch
NC (Normal Close)
ON
NO (Normal Open)
OFF
Not Used
OFF
