www.cls-led.com
www.cls-led.com
- 9 -
- 10 -
Page 6: Resolution
Control resolution 8 Bit.
1 DMX channel per output.
Page 7-10: Patch
To adjust the Patch Value of an output channel
enter the corresponding page and change the
value. The Patch value can be adjusted from 0
– 4. To return to the main menu press the menu
button.
-
Page X: X
Use Up/Down
button
Press the Menu button
to return
Page 6:
Press the Menu button
to enter or return
Page 11-14: Static Value
To adjust the Static Value of an output channel
enter the corresponding page and change the
value. The Static value can be adjusted from 0 –
255. To return to the main menu press the menu
button.
-
Page X: X
Use Up/Down
button
Press the Menu button
to return
Page 15: Record Static value
"YES" = Will copy the DMX values
"No" = Return without recording
-
Page 15:
Use Up/Down
button
Press the Menu button
to return
Page 16: Firmware version
Current firmware version on the LDV-45.
X
Page 16:
Press the Menu button
to enter or return
Page 17: Test loop
Entering this page will result in a test loop on the
outputs of the LDV-45. This enables the user to
test the connections without the need of an DMX
controller. To end the test sequence and return to
the main menu press the menu button.
Test sequence
Page 17:
Press the Menu button
to enter or return
Page 18: Store configuration
After all changes are made the setting need to be
stored before they become active. To store the
settings go to the store page and press and hold
the menu button for 3 seconds. The settings are
stored and you will return to the status display.
Status display
Page 18:
Hold the Menu button
for 3 seconds to store
Page 19: Cancel configuration
When you have made changes but you don’t want
to store them you can cancel the settings. Go to
the cancel page and press and hold the menu
button for 3 seconds. The settings are not stored
and you will return to the status display.
Status display
Page 19:
Hold the Menu button
for 3 seconds to cancel
