7
Steering Column
STEERING AND FRONT SUSPENSION
2
3
5
4
1
6
5
3
2
6
659
Figure 7-1
Steering Wheel Removal
660
Figure 7-2
Steering Wheel Puller
STEERING WHEEL INSTALLATION
NOTE:
To minimize corrosion and to make future removal of the steering wheel easier, apply a small amount of oil or
anti-seize compound to steering shaft before installing the steering wheel.
1.
Install the steering wheel (7) on the steering column shaft (9). Be sure to align the match marks placed on the
wheel and steering column in step 4 above
(Figure 7-3, Page 7-3)
.
2.
Install the steering wheel bolt (6) and tighten to 13 ft-lb (17.6 N·m).
3.
Install the scorecard plate (1).
4.
If required, install the plate mounting screws (8). Tighten screws to 16 in-lb (1.8 N·m).
STEERING COLUMN
See General Warnings on page 1-1.
STEERING COLUMN REMOVAL
1.
Disconnect the battery cables and discharge the controller as instructed.
See WARNINGS “To avoid
unintentionally starting...” and “After disconnecting the batteries, wait 90 seconds...” in General
Warnings on page 1-1.
2.
Remove the steering wheel as previously instructed.
3.
Remove the dash insert, instrument panel, dash assembly, and front bumper. Section 4 — Body and Trim .
4.
Loosen the bolt (11) that attaches the steering column universal joint to the stud on the steering gear
(Figure 7-3,
Page 7-3)
.
5.
Remove the four bolts (10) that attach the steering column to the frame.
6.
Remove the steering column from the vehicle.
Page 7-2
2009 Electric Precedent Maintenance and Service Manual
