Using A Booster Battery (Jump Starting)
1.
Turn the key switch to the OFF position and remove the key. Place the Forward/Reverse handle in the NEUTRAL
position. Chock the wheels.
2.
Access the engine compartment.
See WARNING “For vehicles with cargo beds...” in General Warnings
on page 10.
2.1. Remove the seat bottom.
3.
Disconnect battery and spark plug wires.
See Disconnecting the Battery – Gasoline Vehicle on page 11
.
4.
Use a flat-blade screwdriver, and carefully remove the battery cell caps from the battery.
See following
WARNING.
WARNING
• Wear safety glasses or approved eye protection when servicing the vehicle. Wear a full face shield and
rubber gloves when working on or near batteries.
5.
Carefully check the electrolyte level and add distilled water if necessary. Do not fill the battery cells above
the designated fill line. Replace battery cell caps.
6.
Clean both battery terminals with a solution of baking soda and water (1 cup (237 mL) baking soda per 1 gallon
(3.8 L) of water). Rinse thoroughly. Do not allow this solution to enter the battery. Tighten battery terminals to 80
in-lb (9 N·m). Let the terminals dry and then spray them with Battery Terminal Protector Spray (P/N 1014305).
See following WARNING.
WARNING
• If battery wire terminals are damaged or corroded, replace or clean them as necessary. Failure to do
so may cause them to overheat during operation and could result in a fire, property damage, or
personal injury.
Be sure the battery hold-down clamp is properly tightened. Tighten to 71 in-lb (8 N·m). A loose clamp may allow the
battery to become damaged from vibration or jarring.
If battery appears weak, have it charged by a trained technician. The battery should never be left discharged any
longer than absolutely necessary (do not leave discharged overnight).
USING A BOOSTER BATTERY (JUMP STARTING)
See General Warnings on page 10.
WARNING
• Wear safety glasses or approved eye protection when servicing the vehicle. Wear a full face shield and
rubber gloves when working on or near batteries.
• When jumping from a booster battery, make the final connection the negative (-) cable.
• Do not jump start or charge a frozen or damaged battery. Unplug charger before connecting or
disconnecting cables to the battery. Never lean over battery while boosting, testing, or charging.
If it is necessary to use a booster battery to start the engine, BE CAREFUL!
1.
Turn the key switch to the OFF position. Place the Forward/Reverse handle in the NEUTRAL position, engage
the park brake and chock the wheels.
2.
Ensure the booster battery is 12-volt.
See following NOTE.
NOTE:
A starting battery is recommended but a deep cycle battery can be used if necessary.
3.
Access battery by removing the seat bottom.
4.
Locate the vehicle battery on the passenger side of the vehicle.
2009-2011 XRT 950 Gasoline Vehicle Owner’s Manual
Page 49
