GASOLINE ENGINE, MUFFLER, FUEL SYSTEM,
AND CLUTCHES
Fuel System
15
1
2
3
5
4
4
11
2154
Figure 15-8
Fuel Level Sending Unit Alignment
2156
Figure 15-9
Fuel Level Sending Unit Position
4.
Carefully thread each hex-head screw by hand, with the ring terminal on the black ground wire (6) under the
screw head closest to the engine
.
See following CAUTION.
CAUTION
• Use only the existing screws or new plastic-thread screws made for plastics applications. Do not use
sheet metal screws as replacement hardware.
5.
Use a crisscross pattern to tighten the hardware to 9 in-lb (1 N·m). If the hardware cannot be tightened to 9 in-lb
(1 N·m), the fuel tank must be replaced.
See following CAUTION.
CAUTION
• Do not overtighten the screws. Overtightening the screws will strip the mounting holes in the fuel tank.
6.
Secure the orange wire (7) to the center post with the nut (9) previously removed
.
Tighten the hardware to 17 in-lb (1.9 N·m) and secure the rubber boot (8) to the center post.
7.
Install the passenger seat.
See Seat Installation, Section 4, Page 4-9.
8.
Connect battery and spark plug wire(s).
See Side-Post Battery: Connecting the Battery – Gasoline/Diesel
2016 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual
Page 15-15
Summary of Contents for Carryall 1500 2016
