BODY AND TRIM
Cargo Bed – Electric Lift
4
1446
Figure 4-2
Coiled Seat Belt Assembly
1447
Figure 4-3
Center Seat Belt Fastener
BENCH SEAT BELT INSTALLATION
1.
Install the center seat belt buckle assembly to the seat belt bracket with hardware previously removed except for
the lock nut
. Use a new lock nut. Orient the assembly with the buckle end pointed up
slightly and tighten the new lock nut to 33 ft-lb (44.7 N·m).
2.
Secure the coiled seat belt assembly on the outside of the ROPS seat support with the shoulder bolt and a new
lock nut
. Orient the assembly with the tang end pointed up slightly and tighten the new
lock nut to 35 ft-lb (47.5 N·m).
CARGO BED – ELECTRIC LIFT
See General Warnings, Section 1, Page 1-2.
TESTING THE BED LIFT MOTOR
Gasoline Vehicles: See Test Procedure 35 – Bed Lift Motor on page 11-39.
BED LIFT MOTOR REMOVAL
1.
Make sure the key switch is OFF and the Forward/Reverse handle is in the NEUTRAL position. Remove the
key. Chock the wheels.
2.
Disconnect battery.
See Side-Post Battery: Disconnecting the Battery – Gasoline/Diesel Vehicles on page
1-3.
See Top-Post Battery: Disconnecting the Battery- Gasoline/Diesel Vehicles on page 1-4.
3.
With the bed in the down position, working from under the vehicle, disconnect the two wires from the connectors
at the electric bed lift motor.
4.
Remove the locknut, bolt, sleeve, spacers and washers from the rod end of the bed lift motor and bed frame.
5.
Remove the locknut, bolt, sleeve, spacers and washers from the base of the bed lift motor and vehicle frame
and remove the bed lift motor.
2016 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual
Page 4-11
Summary of Contents for Carryall 1500 2016
