8
Front Hubs
WHEELS, TIRES AND HUBS
3
1
1
2
4
4
2
8
5
6
7
1899
Figure 8-2
Position Steel Blocks and Upright on Press
3.
Press the bearing out of the upright.
3.1.
Position the upright (5) with the two ball joint arms down on one steel block (1) and the drag link arm down
on a second steel block (1)
.
3
2
1
1
10
10
5
7
0.5 in.
(12 mm)
Press ram
0.281 in.
(7 mm)
Radius
2.835 in. (72 cm)
2.909 in. Max. (73.9 cm Max.)
2030
Figure 8-3
Bearing Removal
3.2.
Shim the ball joint arms with steel blocks (2 and 3) to provide a level surface for bearing removal (block 2
height is 9/16 inch and block 3 height is 1-11/16 inch).
3.3.
Make special bar (10), that fits inside cutouts of the bearing cavity opening (7), to rest on the outer race of
the bearing. Press out bearing.
Page 8-4
2016 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual
Summary of Contents for Carryall 1500 2016
