4
Front Body Repair
BODY AND TRIM
Difficult Stains
– Dampen a soft, white cloth with a solution of 10% household bleach (sodium hypochlorite) and
90% water. Rub gently to remove stain, then rinse with a water dampened cloth to remove bleach concentration.
For More Difficult Stains
– Perform previous procedure using full-strength bleach, or allow bleach to puddle on
affected area for approximately 30 minutes. Rinse with a water dampened cloth to remove any remaining bleach
concentration.
See following CAUTION.
CAUTION
• To prevent damage to the vehicle when removing difficult stains or heavy soiling, remove the seat
from the vehicle first.
FRONT BODY REPAIR
See General Warnings, Section 1, Page 1-2.
LIGHT SCRATCHES
1.
Clean entire area to be repaired with clean, clear water.
2.
Using 1200 grit sandpaper, water-sand entire area of scratch until original scratch is no longer visible, either with
finishing sander or wet sanding block. Be sure that sandpaper is centered on sanding pad. Continue to flush with
water while sanding, to increase sandpaper life and keep the sanded surface cool. Wipe repaired area dry and
visually inspect to be sure that the originial scratch has completely disappeared.
3.
Repeat step 2 using 1500 grit sandpaper until all 1200 grit scratches are removed paying close attention to edges.
4.
Install a wool cutting pad (3M #5711 or equivalent) on buffer and spread approx 1/2 tsp. (2ml) of compound (3M
#05955 or equivalent). Buff slowly and steadily over small area so as not to heat surface as this may cause
warping or melting of plastic. Buff sanded area until all sanding scratches have disappeared. Use as much buffing
compound as necessary to achieve this step. If at any time original scratches can be seen, repeat steps 2 and 3
as needed. When all 1500 grit scratches have disappeared, there will be a dull luster over entire area.
5.
Install a foam polishing pad (3M #5725 or equivalent) on buffer and repeat step 4 using approx 1/2 tsp. (2 ml)
buffing compound (3M #5933 or equivalent). Buff compound off until scratches have disappeared. It may be
necessary to apply additional compound to achieve this. The result will be an almost-finished product with a
very high luster and very few buffer swirls.
6.
Using a clean foam polishing pad (3M #5725 or equivalent) and finish glaze (3M #05937 or equivalent), apply a
slightly smaller amount of material than in steps 4 and 5 and buff to desired gloss.
7.
Wipe clean with soft, clean cloth. Any dirt on cloth can mar surface.
ABRASIONS AND HAZE
Abrasions and haze can be greatly minimized by performing steps 5 through 7 above.
LARGE SCRATCHES AND ABRASIONS
Touch-up is not recommended. Replace the entire body part or have it repaired by a professional paint and body
repair shop with experience repairing bodies.
Page 4-2
2016 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual
Summary of Contents for Carryall 1500 2016
