Controls and Indicators
JOYSTICK ON/OFF SWITCH
The joystick ON/OFF switch (18) is located on the rear face of the joystick box. When the switch is placed in the “OFF”
position, the joystick and the hydraulic interface controls will not operate.
KEY SWITCH
The key switch (3) is mounted on the instrument panel to the right of the steering column
(Figure 13)
. It has four
positions: PREHEAT, OFF, ON, and START.
Use the PREHEAT feature if the temperature falls below 23 °F (–5 °C). Do not hold the key in the PREHEAT position
longer than 20 seconds. To preheat glow plugs in cold weather, turn the key to the PREHEAT position, and hold it there
for 10 to 15 seconds. Then turn the key to the START position, and hold it there until the engine starts. If the engine
does not start after 10 to15 seconds, turn the key to the OFF position and repeat the procedure. Once the engine
starts, release the key and it will return to the ON position. The engine will idle in neutral. The engine will continue to
idle until the key is turned to the OFF position.
See following WARNING, CAUTION and NOTE.
Turn the key to PREHEAT position if the temperature falls below 23 °F (–5 °C). Do not hold the key in the PREHEAT
position longer than 20 seconds.
WARNING
• Moving parts! Keep clear of the engine compartment while the engine is running.
CAUTION
• Do not shift the Forward/Reverse handle while the accelerator pedal is pressed. Shift the handle only
when the vehicle is at a complete stop and the engine is at idle. Failure to heed this caution could
result in damage to the transmission.
NOTE:
The key can be removed only when the key switch is in the OFF position.
FORWARD/REVERSE CONTROL
The Forward/Reverse handle (1) is located on the right-hand side of the instrument panel. The handle has three
distinct positions: FORWARD (A), NEUTRAL (B), and REVERSE (C)
(Figure 13)
. Push the handle up to operate
the vehicle in the forward direction, or pull the handle down to operate the vehicle in reverse. The engine can be
started only when the handle is in the NEUTRAL (middle) position. The engine must be at idle before shifting the
Forward/Reverse handle.
See WARNING and CAUTION on page 17.
Club Car vehicles operate at a reduced speed in reverse. If equipped with a reverse buzzer, the reverse buzzer will
sound as a warning when the Forward/Reverse handle is in the REVERSE position.
ACCELERATOR PEDAL
The accelerator pedal (4) is the pedal on the right
(Figure 13)
.
With the engine running and the Forward/Reverse handle in the FORWARD or REVERSE position, vehicle speed
will increase as the accelerator pedal is pressed. When the accelerator pedal is released, it will return to the original
position and the engine will idle.
See WARNING and CAUTION on page 17.
IntelliTach All-Wheel Drive Diesel Vehicle Owner’s Manual
Page 19
Summary of Contents for Carryall 1500 IntelliTach
Page 2: ......
Page 83: ......
Page 84: ...Publication Part Number 103472517 Edition Code 0608G0613F 103472517...
