Engine Oil
directed into the oil pan. A drip guard can be made by folding a piece of cardboard, thin metal, or plastic under
the oil filter, forming a channel to direct the filter port oil into the drain pan.
Dispose of used oil according to the environmental laws and regulations for your area.
4.
Use a clean rag to wipe the oil filter mounting bracket surface clean where the oil filter gasket seats.
5.
Coat filter gasket with clean engine oil
(Figure 61)
. Install the new oil filter (diesel: CC P/N 102703301) onto the
engine oil filter port.
See following NOTE.
NOTE:
Only use oil filters designed for this engine.
6.
Hand tighten 2/3 to 3/4 turn after the filter gasket contacts the mounting surface.
Engine Oil Filling
27
Figure 61
Coat Rubber Seal
212
Figure 62
Add Engine Oil – Diesel Vehicles
1.
Add engine oil
(Figure 62)
. With filter change, the engine requires 3 qt. (2.8 L) for diesel vehicles. Refer to oil
viscosity guidelines for selection of oil grade
(Figure 63)
.
See following CAUTION.
CAUTION
• Do not exceed recommended oil capacity. Doing so will decrease engine performance or result in
damage to the engine.
2.
Install the oil filler cap.
3.
Connect battery.
See Connecting the Battery – Diesel Vehicles on page 11.
4.
With the Forward/Reverse handle in the NEUTRAL position, start and run the engine for three minutes and check
for leaks. Observe both the drain plug and the oil filter from under the vehicle and watch for oil leaks. If the filter
leaks, tighten an additional 1/4 turn and retest. If the oil drain plug leaks, re-torque and retest.
NOTE:
Wait a few minutes after turning off the engine before removing the dipstick.
5.
Remove the dipstick and check the engine oil as a final step. Replace the dipstick.
Page 62
IntelliTach All-Wheel Drive Diesel Vehicle Owner’s Manual
Summary of Contents for Carryall 1500 IntelliTach
Page 2: ......
Page 83: ......
Page 84: ...Publication Part Number 103472517 Edition Code 0608G0613F 103472517...