12
Test Procedures
TROUBLESHOOTING AND ELECTRICAL SYSTEM:
PEDAL-START GAS VEHICLE
2m
20
m
200
m
2k
200
200
200
200
20
2
200
m
500
20k
200k
2000
k
1000
OFF
WAVETEK
5XL
V
V
V
A
!
!
COM
200nA
MAX
1000 ---
750V
FUSED
2
3
1
1. 200 Ohm Setting
2. Disconnect the 6-gauge black wire from the battery. Place red
(+) probe on disconnected end of cable.
3. Place black (–) probe on frame.
Figure 12-8
Battery Ground Cable Test
TEST PROCEDURE 4 – Key Switch (Starter Circuit)
See General Warning on page 1-1.
1.
Disconnect battery and spark plug wire(s).
See Disconnecting the Battery – Gasoline Vehicles, Section
2.
Remove the center dash assembly.
See Key Switch Removal on page 13-17.
3.
Ensure that the wires are connected correctly and are tight. If they are not, rewire or tighten as necessary.
4.
Insert the key and turn the key to ON. Place the red (+) probe of the multimeter on the (2) terminal and the black
(–) probe on the (1) terminal of the key switch. The reading should be continuity. If the reading is incorrect,
replace the key switch
.
1
–M
2
+M
2m
20
m
200
m
2k
200
200
200
200
20
2
200
m
500
20k
200k
2000
k
1000
OFF
WAVETEK
5XL
V
V
V
A
!
!
COM
200nA
MAX
1000 ---
750V
FUSED
1
2
3
4
5
1. Black/White 2. Blue 3. White/Black 4. Red 5. 200 Ohm Setting
456
Figure 12-9
Key Switch Starter Circuit Test – For
Pedal-Start Vehicles
Page 12-14
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
