S10 FE 350 FUEL SYSTEM
Engine Control Linkage
17
Governor Cable Installation and Adjustment
1.
Install the cable onto the governor cable support bracket (10) and the engine bracket (11)
.
2.
Push the cable dust shields onto the ends of the cable conduit.
3.
Connect the governor cable to the carburetor throttle at the carburetor.
4.
Connect the governor cable to the governor lever arm (15)
5.
With the governor lever arm loose on the governor shaft, use a 1/8-inch punch or scratch awl to turn the governor
arm shaft counterclockwise until it stops. Then pull the governor lever arm rearward until the carburetor throttle is
in the “wide open throttle” (WOT) position.
6.
While holding the arm and shaft in the fully counterclockwise position, tighten the governor arm lever nut to
36 in-lb (4.0 N·m).
7.
Check engine RPM adjustment.
See Engine RPM Adjustment on page 17-11.
6
14
12
10
15
17
13
11
1
2
2
6
16
5
3
4
542
Figure 17-9
Governor and Accelerator Cables
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
Page 17-9
